Snowpack report for 12.18.07 | VailDaily.com
YOUR AD HERE »

Snowpack report for 12.18.07

Daily Staff Report
Vail CO, Colorado

EAGLE COUNTY, Colorado ” Check the WEB EXTRAS on the right for a chart showing historical snow water equivalents for Vail, Colorado.

Check out more stats at:

http://www.co.nrcs.usda.gov/



What is Snow Water Equivalent?

Snow Water Equivalent (SWE) is a common snowpack measurement. It is the amount of water contained within the snowpack. It can be thought of as the depth of water that would theoretically result if you melted the entire snowpack instaneously.



For example, say there is a swimming pool that is filled with 36 inches of new powdery snow at 10% snow water density. If you could turn all the snow into water magically, you would be left with a pool of water 3.6 inches deep. In this case, the SWE of your snowpack would equal 36″ x 0.10 = 3.6 inches.

The NRCS measures SWE at many remote SNOTEL sites and uses the data for stream flow forecasting. However, many scientists and recreationists are interested in snow depth instead of SWE. The relationship between the two values is explained here.

To determine snow depth from SWE you need to know the density of the snow. The density of new snow ranges from about 5% when the air temperature is 14° F, to about 20% when the temperature is 32° F. After the snow falls its density increases due to gravitational settling, wind packing, melting and recrystallization.



Most snow that falls in the Cascade Mountains of Washington and Oregon tends to be higher density snow. In the Cascades, snowpack densities are around 20-30% in the winter to 30-50% in the spring. However, east of the Cascades, the snowpack density is much less. Typical values are 10-20% in the winter and 20-40% in the spring.

To determine the depth of snow using snow water equivalent and density, use the following formula:

[SWE] ÷ [Density] = Snow Depth

(Density must be in decimal form. For example: 25% = 0.25)


Support Local Journalism